I/O board is working, voltages goes to the mainboard.
By looking at the power states, SMC_PM_G2_EN must be enabled even when the laptop is turned off (S5 state), but this signal is missing.
What i don't know if this signal is enabled from another pin of the smc, or just turn it on when power is given to the chip.
I think i will only know that when i replace the smc chip..
By looking at the power states, SMC_PM_G2_EN must be enabled even when the laptop is turned off (S5 state), but this signal is missing.
What i don't know if this signal is enabled from another pin of the smc, or just turn it on when power is given to the chip.
I think i will only know that when i replace the smc chip..
16 volts, 12 volts ok & even replace ISL charging IC but still same prob ie no
3.3v & 5 votls stanby voltages missing.
1) no SMC_PM_G2_EN ie .4voltsv.
2) no SMC_RESET_L ie .4 volts.
3) no SMC_ADAPTER_EN ie .4volts
BUT after Reflow or appling Heat to SMC IC problem resolve.
1) no SMC_PM_G2_EN ie 3.4voltsv.
2) no SMC_RESET_L ie 3.4 volts.
3) no SMC_ADAPTER_EN ie 3.4volts.
and ALL my voltages came up.
heheh Enjoy...
No comments:
Post a Comment